RMS MMS Sample Code

Configuration Update

1

Go to the folder: rms_mms and open a terminal.

2

Connect the reader to a USB port.

3

Enter command below. Enter password if prompted. This is for device port access.

$ sudo ./rms_mms_config_update

4

A list of available configurations is returned. List depends on the firmware ID and RMS Profile. Example:

Device Serial Number:B568DAF
Main Firmware ID:1000009714-AB3-PCI Response Code:200
ResultCode: 0 Result: Success
Configurations Available: 3
1: Mask4Zero4
2: SCDEEnableNameExpirationDateServiceCode
3: Mask8Asterisk4_DynaFlex
Enter '1'...'3' to update configuration.
To force update configuration, enter '*' before the number ('*1'...'3').
Enter '0' to exit:

5

At the prompt, select a configuration by entering its number listed to its left. A sequence of commands are downloaded from RMS and sent to the reader. Status of the configuration is shown as updated or failed and the end of the sequence.

Selected Configuration 1 Updating Configuration... Configuration: Mask4Zero4 CommandsToDevice (1)
Name: LeadingUnmaskedCharacters Command:
SENDCOMMAND,AA0081040110D111841BD11181072B06010401F609850101890BE109E2 07E205E103C30104
CommandsToDevice (2)
Name: PANMaskedCharacter
.
.
.
Configuration Mask4Zero4 has been updated.

6

Whenever a configuration reports is up to date, it may be redone by entering *N, where N is the configuration. Example: *1

EMV Tags/CAPKs Update

1

Go to the folder: rms_mms and open a terminal.

2

Connect the reader to a USB port.

3

Enter command below. Enter password if prompted. This is for device port access.

$ sudo ./rms_mms_firmware_update

4

The parameters for the firmware update is as follows:

rms_mms_firmware_update TYPE
    TYPE (type of firmware): MAIN|BOOT1|BLE|WLAN

5

Example for updating MAIN firmware.

$ sudo ./rms_mms_firmware_update MAIN

6

If an update is available, the change note for the update is shown. Below that, a confirmation to update is shown. Enter y to update.

Firmware update is available.
New Firmware: FIRMWARE, DYNAFLEX II GO MAIN APP PCI (COMMON KERNEL),
Version AB3
.
.
.
Do you want to update the MAIN firmware? (y/N)

7

A sequence of commands are downloaded from RMS and sent to the reader. Status of the update is shown as finished or failed and the end of the sequence.

Updating MAIN firmware...
Beginning DYNAFLEX II GO MAIN APP PCI (COMMON KERNEL)
Updating firmware... [1%]
.
.
.
[100%]
result (0)
Firmware update done.
Saving Firmware Image - Please Wait... Wait for 30000 ms...
Done waiting. Detecting device...
Detecting Device: GetDeviceList Detecting Device: GetDeviceList > 0 Detecting Device: Found USB Device Device detected.
Finished DYNAFLEX II GO MAIN APP PCI (COMMON KERNEL)