Notifications

MMS notifications are the asynchronous messages the DynaProx reader sends while a transaction is running, reporting progress, state changes, and completion. Find the Notification Group you are looking for below and follow the links in the table to jump to a specific notification.

Applies to: DynaProx

From Transactions - Source 0x01nn

Reference Section	Information Available
Transaction Information Update - Notification 0x0101	This notification reports information about progress and state changes that occur during a transaction.
Transaction Operation Complete - Notification 0x0105	This notification reports the final result of a transaction the host initiated using Command 0x1001 - Start Transaction.

Firmware Updates - Source 0x09nn

Reference Section	Information Available
Firmware Update Successful - Notification 0x0905	This notification reports the successful completion of firmware update operations the host initiated
Firmware Update Failed - Notification 0x0906	This notification reports the failure of a Firmware Update command the host initiated.
Firmware is Up to Date - Notification 0x0907	This notification reports Firmware is up to date for host initiated update.

From Device - Source 0x10nn

Reference Section	Information Available
Device Information Update - Notification 0x1001	This notification reports information about general state changes that occur within the device, outside the context of specific operations like transactions
Low Battery Warning - Notification 0x1001	The device sends this notification when the battery charge reaches 15 percent.
Low Battery Shutdown - Notification 0x1001	The device sends this notification one minute before it automatically powers down the device.
Battery Charged - Notification 0x1001	The device sends this notification when the battery charger detects that the battery is fully charged.

User Interface - Source 0x18nn

Reference Section	Information Available
User Interface Host Action Request - Notification 0x1803	This notification requests that the host take action during operations involving the device’s User Interface modules.
User Interface Operation Complete - Notification 0x1805	This notification shows that a UI operations involving the device’s User Interface modules is complete.

For more help

Need Help?

For additional support, please contact MagTek Support:

Technical Support:

• 📧 Email: [e-mail]

• 📞 Phone: [phone] (US)

• 🕐 Hours: Monday-Friday, 5:30 AM - 5:00 PM PST

Online Resources:

• 🌐 Support Portal: developer.magtek.com

Documentation Feedback:

Help us improve this documentation! [e-mail]