Command 0x3001 – Pass-Through Mode Start/Stop

The host uses this command to enter or exit Pass-Through Mode.

The Host must “Enter Pass-Through Mode” prior to using any other commands in this section. Otherwise, subsequent commands will be “ignored” / “rejected”. When finished, the Host should “Exit Pass-Through Mode”. Once exited, the reader returns to its “normal state” and will accept traditional commands.

Table ‎- Request Data for Command 0x3001 – Pass-Through Mode Start/Stop

Tag	Len	Value / Description	Typ	Req	Default
Beginning of any wrappers, at minimum including Request Message
3001 = Command 0x3001 – Pass-Through Mode Start/Stop
81	01	This parameter defines how long the device to stay in the Pass-Through Mode · 0x00 = No timeout · 0x01 to 0xFF = 1 to 255 seconds		R
82	01	Pass-Through Mode · 0x00 = Stop Pass-Through Mode. This mode can only be used after the device in the Pass-Through Mode. The device automatically turn off the RF Antenna after exit the Pass-Through Mode. Device returns error if it is not in the Pass-Through Mode. · 0x01 = Start Pass-Through Mode. This mode can only be used when the device is in Idle state.	B	R
End of any wrappers, at minimum including Request Message

Table Response Data for Command 0x3001 – Pass-Through Mode Start/Stop

Tag	Len	Value / Description	Typ	Req	Default
Beginning of any wrappers, at minimum including Response Message
No parameters.
End of any wrappers, at minimum including Response Message

Table Request Example

Example (Hex)
AA 00 81 04 01 9F 30 01 84 08 30 01 81 01 00 82 01 01

Table - Response Example

Example (Hex)
AA 00 81 04 82 9F 30 01 82 04 01 00 00 00