Command 0x1F05 – Erase All Bluetooth® LE Bonds (Bluetooth® LE Only)

The host can use this command to erase all Bluetooth® LE bonds. The user should then forget the device and re-pair the device on any host that it was previously paired with if that host needs to communicate with the device again.

The sequence of events is as follows:

1

Construct the command request

The host constructs the command request for Command 0x1F01 - Reset Device in the format below.

2

Send the command

The host sends the command request to the device.

3

Device responds

The device sends a response in the format below to the host.

4

Device erases bonds

The device erases all Bluetooth® LE bonds within around 500ms.

Table - Request Data for Command 0x1F05 – Erase All Bluetooth® LE Bonds

Tag	Len	Value / Description	Typ	Req	Default
Beginning of any wrappers, at minimum including Request Message
1F05 = Command 0x1F05 – Erase All Bluetooth® LE Bonds
No parameters.
End of any wrappers, at minimum including Request Message

Table - Response Data for Command 0x1F05 – Erase All Bluetooth® LE Bonds

Tag	Len	Value / Description	Typ	Req	Default
Beginning of any wrappers, at minimum including Response Message
1F05 = Command 0x1F05 – Erase All Bluetooth® LE Bonds
No parameters.
End of any wrappers, at minimum including Response Message

Table - Request Example

Example (Hex)

AA 00 81 04 01 55 1F 05 84 02 1F 05

Table - Response Example

Example (Hex)

AA 00 81 04 82 55 1F 05 82 04 00 00 00 00 84 02 1F 05