How to use the Firmware Update Utility

Introduction

This document provides the instructions to update firmware into a MagTek DynaFlex or DynaProx device on a Windows PC via USB connection.

System Requirements

• A Windows 10 host with available USB port

• Microsoft .NET 4.6.1 and above.

• DynaFlex, DynaProx, or DynaFlex Pro

• USB-C cable with USB Type-A or USB-C for host connection

• Software 1000007405 DynaFlex, DynaProx Firmware Update Utility

• Firmware files provided by MagTek

Connect via USB Interface

To connect to the device follow these steps.

• Connect a DynaFlex or DynaProx to the USB port of the Windows PC.

• Launch the DynaFlex, DynaProx Firmware Update Utility.

• Press the Scan button to update the list of devices.

• Select a device from the list, then press the Connect button to connect to the device.

• The status will display Connected .

Upload Firmware

• Press the Browse button, select the firmware file, and then press the Open button.

• The software will automatically detect the firmware type.

• Press the Start Firmwre Upload button to begin the upload.

• Wait until the Firmware Upload is complete. The progress of the upload will change to prepare, downloading, and updating.

DO NOT power off or disconnect during the upload.

• After uploading, the DynaFlex, DynaProx Firmware Update Utility will display Firmware Successfully Updated . Press the OK button. The device will automatically reboot after a completed firmware update.

• If you want to get current information about the device such as firmware version, firmware hash, select the desired information under the Info drop down and press the Get Info button.