Ctrlk
For the complete documentation index, see llms.txt. This page is also available as Markdown.
ChatGPT

How to Connect to Devices Using DynaFlex Utility

To connect via an interface listed in the Connection Type box, follow these steps.

How to Connect Using the USB Connection

  • For best results, use the cable that is included with the device.

  • Connect the USB-C end of the cable to DynaFlex device.

Figure - Connecting DynaFlex to a USB Host

  • If you plan to route the cable out the back of the device, route the cable through the cable management clip to change its direction. Even if you are not routing out the back, you may use the cable clip for strain relief, to help stabilize the mechanical connection when cardholders or operators move the device or the cable.

  • Route the cable in the desired direction (e.g., out the back, left, right, or down into the countertop).

  • Connect the other end of the USB cable to the host’s USB port.

  • As soon as the device starts receiving power through USB, it automatically powers on.

  • Launch the DynaFlex Utility and select DynaFlex device in the Device Type list, then press the connect button.

  • The Output log shows the status of the connection.

  • To disconnect the device, press Disconnect button.

How to Connect Using the Bluetooth LE Connection

The following instructions are for pairing the DynaFlex II GO to a PC.

  • Launch the DynaFlex Utility to connect to the device by USB connection. Obtain Bluetooth LE Device name from selecting the Settings tab, Wireless/BLE menu, and at Bluetooth LE Settings press the Get button for Device Name

  • Place the device into Pairing Mode by pressing and holding the power button on device until 4 beeps and release the button. The 4th LED will blink green.

  • On the PC, open Settings and choose Bluetooth & other devices. Make sure the “Bluetooth” is turned ON . On the right panel, choose Add Bluetooth or other device.

  • At the Add a device window, select Bluetooth.

  • To pair, click on the device name that was been retrieved from DynaFlex Utility.

  • Enter the PIN, (“000000” by default), and press Connect .

  • Go back to DynaFlex Utility, disconnect the current USB connection.

  • Click on Device list to find the added BLE device similar as below.

Last updated