How to use the MTNET OEM Demo via USB Interface

The following instructions detail how to use the MTNET OEM Demo with mDynamo or DynaDip on Windows PC via USB interface.

MTNET OEM Demo queries for device features upon connecting. Some demo features are disabled based on what is supported on the device. MTNET OEM Demo does not automatically set Time.

• Connect the device to the USB port of the Windows PC.

• Launch the MTNET OEM Demo and press the button to scan for connected USB devices

• If your device has an additionally attached device to its SPI or UART port, select the appropriate device type in the list for SPI port and UART Port before connecting.

• Select the Device ID and press the Connect button to open the device

• Swipe a magnetic stripe card to read the card data if you have an attached MSR head.

• To send a command to the device, enter the command in the command text box, select the appropriate device to send to and press the Send Command button..

• To read a chip card, press the Set Time button and send to the Board. If you have an attached NFC module connected to the UART port, press the Set Time button, and send the UART before reading a contactless card.

• To begin an EMV transaction, select desired Transaction type and Response, press the Start button, and then present the appropriate card whenthe Present Card message appears.

• Select an Application in the Select Application window.

• If you want to cancel the EMV transaction, press the Cancel button. Please note that the cancel feature will only work before the card is inserted.

• To clear the screen, press the Clear button.

• To close the device, press the Disconnect button