Device Control - Command Group 0x1Fnn

Device Control

This section of the DynaFamily Programmer's Manual lists available Device Control commands to initiate various functions in the device.

Applies to: All Dyna Family products

Information in this group

Section	Information
Reset Device	The host uses this command to reset the device.
Set Notification Subscriptions	The host uses this command to specify which notifications the device should send on each of its available interfaces.
Extend Session (Session Managements Only)	The host can use this command to extend a session for open protocol interfaces, such as the WLAN interface, which require session management to meet PCI requirements.
Terminate Bluetooth LE Connection	The host can use this command to terminate a Bluetooth LE connection.
Erase All Bluetooth LE Bonds	The host can use this command to erase all Bluetooth® LE bonds.

Need More Help

Need Help?

For additional support, please contact MagTek Support:

Technical Support:

• 📧 Email: [e-mail]

• 📞 Phone: [phone] (US)

• 🕐 Hours: Monday-Friday, 5:30 AM - 5:00 PM PST

Online Resources:

• 🌐 Support Portal: developer.magtek.com

Documentation Feedback:

Help us improve this documentation! [e-mail]