0x30nn - Generic Pass-Through Commands

Generic Pass-Through Commands

Pass-Through Mode is independent and separate from EMVCo Payment functions. This mode is typically used by developers that require the need for non-payment low-level APDU communications with NFC cards, tokens, and devices.

Applies to: All Dyna Family products

Information in this group

Section	Information
About	Basic information about generic pass-through commands
0x3001 - Pass-Through Mode Start/Stop	The host uses this command to enter or exit Pass-Through Mode.
0x3002 - Start/Top Polling	After entering the Pass-Through Mode, the host use this command to request the device to start polling for a Type A and Type B PICC until it detects a PICC or times out.
0x3003 - SO 14443-4 APDU Pass-Through Commands	After the NFC Type A or Type B card is activated, the host uses this command to send application-level APDUs to a PICC that supports ISO 14443-4 Protocol.

Need More Help

Need Help?

For additional support, please contact MagTek Support:

Technical Support:

• 📧 Email: [e-mail]

• 📞 Phone: [phone] (US)

• 🕐 Hours: Monday-Friday, 5:30 AM - 5:00 PM PST

Online Resources:

• 🌐 Support Portal: developer.magtek.com

Documentation Feedback:

Help us improve this documentation! [e-mail]